Skiply Clock E Date Time Skiply Clock E Date Time How to Change Time & Date on a Skiply Feedback Device Unscrew the four finger-tight chrome screw caps. Use a Philips head screwdriver to remove the four screws found underneath. Note: Be careful not to lose the four brass spacers. Remove the front face plate and turn the device over and gently tap the back. Remove the four screws on the back of the display board with a Philips head screwdriver. Carefully turn over the board so that the display faces upwards. Note: the display may be blank if a battery change has been performed. Identify the two control buttons BP1 and BP2 near the edge of the board to the right. BP1 (red) enters/exits the settings menu and is used to scroll the cursor through the available menu options: Language, Time adjust, Date, Time. BP2 (green) changes the value within the setting menu chosen. Press the BP1 button once. The display will flash and then the settings menu will be displayed Language. If the language displayed is not English: a. Press the BP2 button until English is displayed. b. Press the BP1 button to confirm. The cursor will then cycle to the next menu option. Time adjust. a. Press BP2 until yes is displayed. b. Press BP1 button to confirm. The cursor will then cycle to the next menu option. NB: For setting Date & Time, please pay attention to where the cursor is and pressing BP1. To correct an error you will need to cycle through all the settings using BP1, to exit then re-enter the settings menu and restart from Step. 7 Date. a. The cursor will land on the first-place digit in the sequence of year/month/day ie. “[2]{.underline}024/03/30” b. Press BP2 button to change the number until the desired digit is displayed. c. Press BP1 button to confirm. The cursor will then cycle to the next place digit in the sequence ie. “2[0]{.underline}24/03/30” d. Repeat the above to set and confirm the desired year/month/day. e. When finished, press BP1 button to confirm. f. The display will flash and then display: “99 days ago at 00:00” Return the display board into its correct position, fix the board in place with the four screws. Ensure the black rubber seal is correctly tightly within the groove of the backplate. Fit the faceplate onto the backplate, ensure the seal has not moved. Screw in the four corner screws. Note: take care not to overtighten the screws, this can deform the brass spacers. Lastly, fit and finger-tighten the four chrome screw caps. Perform Badge-In. The display should be on and display “Today at…” with the current time. You can find a link how to Badge-In here: Badge-In Video The time and date have now successfully been set. Did this doc help you? For further questions or support, please contact us at support@microshare.io